janstanka

## --- BIQU BX (SKR-BX 2.0) with Microprobe V2 Klipper configuration ---
# I used MicroProbe with bracket for Ender3 (SKU: 1060000587*1+1060000658*1)

# Not much different from a standard probe config. The
# main difference compared to most probes is to disable
# deactivating the probe (PROBE_UP) after each sample

# Note: if you are changing from a bltouch or one of its
# clones, remove/comment out the [bltouch] config!
# That also includes any auto generated config stored

looxonline

BIQU BX RASPBERRY PI TIDY INTEGRATION MOD

The BIQU BX is advertised as "RPi integrated". This statement can understandably cause a lot of confusion as to what it actually means. Some people have an expectation that it means that the pi will not need to connect to the front USB port of the machine. Others may have a different expectation.

The reality is that the integration comes in the form of a very clean mounting solution for the Pi combined with the ability to power and interface with the pi using the machine (touch interface). The USB port on the back of the TFT that connects to the pi does not offer a serial link back to the motherboard. It simply interfaces with a little MCU (CH554G) that translates the I2C signals from the touch controller on the TFT into signals that the pi can understand over USB. If you want the raspberry pi to communicate with the motherboard in order to send and receive commands (hint: you do) then you are still going to need a USB cable running from the pi to the micro USB po