ithygit

#For using RCWL0516 microwave motion detectors. Using a dev/breakout board I find is easiest for this.
#ESP8266 Pins | RCWL0516/Connection | Comment| 
#| VIN | 5v from PSU | Provides 5V to the ESP8266/Alt use the breakoutboards DC
#| VU/5V | VCC on RCWL0516 | Powers the module with 5v from esp's rails, pref add cap/direct power, just remember the earth back to the esp
#| D2/GPIO4 | OUT on RCWL0516 | RCWL sends HIGH signal when motion detected |
# Tune the way you wish this sensor to be triggered, ideally on the esphome to reduce the flapping/sensitivity of this module.
# Use several or other detectors for confidence in precense detection

esphome:
  name: esp8266room

ithygit

#ith - v1 - backlight untested, works good otherwise, use buttons to cycle
esphome:
  name: ttg
  platform: ESP32
  board: featheresp32
  
font:
  - file: 'fonts\slkscr.ttf'
    id: font_slkscr_8
    size: 8

ithygit

import glob
import os
import sys
import time
from math import sqrt

from pyproj import Geod, Transformer

try:
    sys.path.append(glob.glob('../carla/dist/carla-*%d.%d-%s.egg' % (

ithygit

Flashing Kogan smart devices w/ Tasmota using tuya-convert

I bought the following devices from Kogan (AU):

• KASB10WRGBCCTB22A Kogan SmarterHome 10W RGB+CCT Color & Warm/Cool White Smart Bulb (B22)
• KALEPDLRGBCCTA Kogan SmarterHome Smart LED Downlight
• KASB10WRGBCCTE27A Kogan SmarterHome 10W RGB+CCT Color & Warm/Cool White Smart Bulb (E27)
• KASPEMHUSBA Kogan Smart Plug With Energy Meter (and 2 x USB)
  • NOTE: Same device as MS6104 Jaycar Smart Plug WiFi Controlled Main Switch and Energy Monitor with 2 x USB Sockets